The
TRIPLE METER HOOD allows Defi-Link Meters and Defi-Link Meter BFs
to be mounted on Subaru New Age Impreza.
Meter are not included(sold separately).
Product is not painted(undercoated).
Meters don't face the driver's side but to the center.
Triple Meter Hood - SAFETY
WARNING -
indicates a risk of death or serious injury.
Indicates a risk of personal injury or damage to equipment.
All the installation in this manual must be followed to ensure
safety installation and operation of the product.
After the installation, please confirm that electric and electronics
system work correctly.
Triple Meter Hood - PARTS
LIST -
Triple Meter Hood - SPECIFICATIONS
-
Applicable model/type
Subaru New Age Impreza GD/GG E type '00.08~
Material
Heat-Resistance ABS
Size(inch)
10.7(W) x 3.8(H) x 8.2(L)
Size(mm)
Weight(lb)
1.06
Surface finish
undercoated (unpainted)
Installable gauges
2 3/8"(60mm)gauges
(Defi-Link Meters and Defi-Link Meter BFs are recommended)
*Other brands' gauges may not fit the holes of the hood.
*Regular Position Bezel cannot be installed in combination
with the Triple Meter Hood for New Age Impreza.
Triple Meter Hood - HOW
TO INSTALL -
1. Install gauges
Fit gauges into the holes of the hood and push
rubber-boots on gauges from the backside of the hood.
Clear away dirt from the gauge.
Push the rubber-boots tightly on the back of the
face panel.
2. Dismantle the clock hood
Remove the clock hood from the instrument panel.
Please mind that the clock hood has six hooks. Disconnect the
clock wire connector.
The clock wire has to be fixed somewhere to avoid
noise and short circuit.
3. Install the Triple Meter
Hood
Install the Triple Meter Hood with gauges where
the clock hood was originally placed.
Hooks may be broken if the excessive force is
applied, so please be careful when installing.
4. Attach the Defi emblem
Attach the Defi Emblem anywhere you like.
PAINTING
1.
The Triple Meter Hood Surface is undercoated.
Please file the surface smooth gently with sandpaper(#800 or
finer one) before painting.
2.
If you require better surface finish, please dismantle
six screws from the backside of the Triple Meter Hood. Then
paint the face panel and the hood separately. After the paint
gets dry completely, please reassemble the screws and the hood.
(Recommended tightening torque is between 50N and 80N.)
Do not file the surface too much.
Paint for plastic must be used.
Visit eShocks.com for great prices on premium Bilstein, Edelbrock and Koni shocks and struts for street, off-road and racing. Save on shipping by combining an order with your gauges!
Automotive
The
TRIPLE METER HOOD allows Defi-Link Meters and Defi-Link Meter BFs
to be mounted on Subaru New Age Impreza.
